Search
140 articles for “silicates”
-
Catalytic hydrogenation of dimethyl-nitrobenzene to dimethyl-aniline over Ni catalysts
Abstract: The catalytic transfer hydrogenation of dimethyl-nitrobenzene (DN) to Dimethyl-aniline (DA) was studied in the temperature range 343–403 , pressure range of 4–10 bar H2 and ethanol as solvent using Ni on alumina-silicate as catalyst above agitation speed 800 rpm. The substrate feed concentration was varied in the range from 0.124 to 0.745 kmol/m3 while catalyst loading was in the range 4–12% (w/w) of dimethyl-nitrobenzene. Dimethyl-aniline was the only reaction product, …
Published in International Journal of Chemical Engineering and Processing · Vol. 3, Issue 2, 2017 · pp. 19–29 Read article
-
Chemical Synthesis and Characterization of Polyaniline for Supercapacitors Application
Abstract: Various polyaniline (PANI) synthesis methods are reported in the literature, depending on the experimental parameters involved (T, t, doping, and mixing procedure). Herein, three chemical polymerization methods were used to synthesis PANI from aniline monomer: rapid oxidation (OR), controlled oxidation (CO), and interfacial oxidation (OI). The PANI was therefore deposited next by drop casting on a silicon (Si) substrate. X-ray diffraction, Raman spectroscopy, and scanning electron microscopy were used to …
Published in International Journal of Chemical Engineering and Processing · Vol. 8, Issue 2, 2022 · pp. 9–16 Read article
-
EFFECT OF ALGAE & COAGULANTS ON PHARMACUTICAL EFFLUENT CHARACTERSTICS
Abstract: Pharmaceutical industry effluents may contain many elements including calcium, magnesium, silica, chromium nickel, iron, cobalt, zinc etc. These heavy metals which are produced by the industrial waste are a big threat for the environment. They can also harm the ecosystem. In this study biochemical treatment of algae and coagulants was given to pharmaceutical industry effluent and reduction in polluting parameters was determined. It was observed that in the presence of …
Published in International Journal of Environmental Chemistry · Vol. 5, Issue 1, 2019 · pp. 1–3 Read article
-
Development of Geo-Polymer based Light Weight Bricks
Abstract: Light weight geopolymer bricks were developed during this study. The mix was made with lime sodium silicate and fly ash as ingredients. A maximum shrinkage was observed at CaO lime ratio of 1.0. Bulk densities were also lower at the ratio of 1.0. The maximum cold crushing strength (CCS) value was found at the ratio of 0.745. Increase in mix water decreased the strength. Water content of 24% is recommended …
Published in International Journal of Chemical Synthesis and Chemical Reactions · Vol. 1, Issue 1, 2015 Read article
-
Synthesis and Characterization of Cadmium exchanged Sodalite
Abstract: Cadmium derivative of chloro sodalite, has been synthesized at low temperature by hydrothermal method. The sodalite is characterized by IR, X-ray powder diffraction and SEM. The Cd derivative was obtained by facile exchange of cadmium for sodium in chloro sodalite using a solution of cadmium nitrate in Teflon autoclaves at 100oC. The IR spectra of parent gallo silicate chloro sodalite and cadmium exchanged chloro sodalites shows three kinds of IR …
Published in International Journal of Chemical Synthesis and Chemical Reactions · Vol. 2, Issue 1, 2016 Read article
-
Preparation and Characterization of Ce-Si-SBA-15 Modified With Iron
Abstract: Recently environmental concerns have driven the development of specialized catalysts to prevent polluting substances from being released into the environment. New technologies have improvised our understanding of catalytic functions as well as selectivity in order to save the energy and chemicals. Today, catalysis is the workhorse in the chemical industry with approximately >90% of the products produced in catalytic processes. In addition, life cannot exist without catalysis, as virtually all …
Published in International Journal of Chemical Synthesis and Chemical Reactions · Vol. 2, Issue 1, 2016 Read article
-
Eco-friendly Color Production for Holi Celebration: A Mini Review
Abstract: Many synthetic colours formed from chemicals have adverse effects on environment. Biocolours are nowadays used in holi festival. Colours are also becoming integral part of modern day life. Use of colours are becoming a part of our everyday life. There is need of nontoxic colours in order to remove substances like lead, cadmium, chromium and cobalt entering in the food chain. Biocolours are mainly prepared from plant origins. The current …
Published in International Journal of Chemical Synthesis and Chemical Reactions · Vol. 8, Issue 1, 2022 · pp. 7–12 Read article
-
Synthesis of Low Cost Artificial Sand From Fly ash and its Application as a Filter Material
Abstract: The usage of natural river sand is increasing vastly. Geopolymers are materials with three-dimensional alumina silicate structures that have a high mechanical strength and can be used as an alternative to Portland cement. The probability of using Natural river sand can also be replaced with geopolymer synthetic sand. There are many properties which may lead the scarcity of natural riversand they are Because of landslides, tsunamis and erosion. The GPSS …
Published in International Journal of Chemical Synthesis and Chemical Reactions · Vol. 8, Issue 2, 2022 · pp. 15–24 Read article
-
Graphene Modification for Thermal Modulators: A Current Report
Abstract: Graphene has attracted a lot of interest in recent years on account of its unique electrical and optical properties. Graphene has a spring constant in the range of 1-5N/m and a Young's modulus of 0.5 Tpa, which shows that it has a breaking strength 200 times greater than steel and one of the strongest materials known. Moreover, the electronic structure of graphene is unique in the sense that it can …
Published in International journal of Thermodynamics and Chemical Kinetics · Vol. 2, Issue 1, 2016 · pp. 28–29 Read article
-
Crystals (Thermotropic phases and Lyotropic phases) in Physical Properties
Abstract: In the current years there has been a cumulative growth to add the numerous nanomaterials to liquid crystals which is encouraged via frequent elements of resources advance. (i) accumulation of nanomaterials can conversion and thus melody the belongings of the liquid crystal (ii) inventive functionalities can be added to the liquid crystal (iii) the self-organization of the liquid crystalline formal can be abused to pattern systematic structures or to assignment …
Published in International journal of Thermodynamics and Chemical Kinetics · Vol. 5, Issue 2, 2019 · pp. 16–22 Read article
-
Developments of Glass-Ceramics in Modern Scenario
Abstract: This article is a study on glass science and methods to achieve esteem. Synthetic protocols has been implacable secure to obtain glass-ceramic properties. First glass-ceramic capability has been introduced by Stookey in 1950s’. His excellence has reticulated control on devitrification of glass by adding nucleating agent i.e. TiO2 in 1960s’. Extendable pursue has rated score depending on sinter philosophy on glass-ceramics as well former scripture that has been etiquette of …
Published in International journal of Thermodynamics and Chemical Kinetics · Vol. 7, Issue 2, 2021 · pp. 23–31 Read article
-
Performance of Metakaolin and GGBS-induced Geopolymer Concrete Under Compression
Abstract: Metakaolin and ground granulated blast furnace slag (GGBS) were used as the source materials to obtain the high strength geopolymer concrete. NaOH and sodium silicate were used as alkaline activators with varying NaOH molarities of 8M, 12M, 14M and 16M. Cubes of size (100x100x100) mm were cast and the four geopolymer mixes were heat cured for varying durations of 24 hours, 48 hours and 72 hours and tested for compressive …
Published in International Journal of Concrete Technology · Vol. 3, Issue 2, 2017 · pp. 31–38 Read article
-
Suitability of Concrete Containing Fly Ash Along with Alccofine
Abstract: With the growing urbanization and rising standard of living and purchasing power of men the demand of concrete does not look to become dormant. But due to limited supply of non-renewable constituents of concrete they are needed to be preserved for the future generation, so there is utmost necessity of using supplementary waste materials in concrete. With advancement in science and technology itis made possible that the waste materials like …
Published in International Journal of Concrete Technology · Vol. 4, Issue 1, 2018 · pp. 15–20 Read article
-
Aerocon Bricks
Abstract: Various low-cost housing projects are considered by a growing demand chiefly due to urbanisation. The collection of building materials should chance the requirements of local conditions to enhance quality of life for the most needed ones by building new structures and/or by improving existing structures. Various studies showed that a big variety of wall materials have been used in different building systems with traditional and modern construction methods, but only …
Published in International Journal of Concrete Technology · Vol. 4, Issue 2, 2018 · pp. 37–48 Read article
-
Experimental Study of Mechanical Properties Geopolymer Concrete.
Abstract: This experimental study aimed to define the parameters for optimum mix design of geopolymer concrete made by partial replacement of cement. The geopolymer concrete is nothing but the formation of fly ash and alkali activators. Fly ash is the waste product from the thermal power station and may use as the pozzolanic material. But, only fly ash is may not the only replacement for the cement, for the more binding …
Published in International Journal of Concrete Technology · Vol. 5, Issue 2, 2019 · pp. 16–22 Read article
-
Effect of Temperature on mechanical properties of Geopolymer concrete: A Review
Abstract: Concrete is the most widely used material after water in building and construction field. It is the oldest man-made material and is easily available for use at cheaper costs. This material is causing harm to environment on mass extent. OPC i.e. Ordinary Portland Cement is second contributor after automobile industry in Carbon Dioxide emission. This review presents the study of replacement of regular concrete cement with cementitious material like fly …
Published in International Journal of Concrete Technology · Vol. 7, Issue 1, 2021 · pp. 24–28 Read article
-
Stabilization of Red soil by using Boiler Feed Ash
Abstract: Red soil is the one of the irrigation soil. Most of plants are grown in this soil. The red soil has the most iron content when compared to other soils and it has also got various chemical properties. The red soil has less bearing strength and more water permeability. By the addition of fly ash and BFA to the red soil the liquid limit, plastic limit and bearing strength can …
Published in International Journal of Geological and Geotechnical Engineering · Vol. 1, Issue 1, 2015 · pp. 9–13 Read article
-
Application of Suitable Admixtures (Lime and RHA) for Improvement of Pavement Subgrade
Abstract: Abstract The quality of a pavement depends on the strength of its sub-grade. The present investigation has been carried out with easily available materials like lime and rice husk ash mixed individually and in combinations with different proportions. The different percentages of lime with respect to weight of dry soil were 2%, 4%, 6%, 8% 10% and for rice husk ash (RHA) were 3%, 6%, 9% and 12%. In each …
Published in International Journal of Geological and Geotechnical Engineering · Vol. 1, Issue 2, 2015 · pp. 14–31 Read article
-
Power and Body-Bias Optimization for FD-SOI Systems-Via Simulations and Algorithms
Abstract: The field of Integrated Circuits is very vast from digital to analog circuits dealing withvarious types of digital circuits our paper deals with the CMOS digital circuits poweroptimization. The paper deals auto-characterizing different FD-SOI circuits with certainmachine learning techniques verifying their outputs along with managing power losses andbody bias voltages in different temperature conditions the machine learning techniques helpoptimize power losses by varying body bias voltages according to the functional …
Published in International Journal of Electrical Power System and Technology · Vol. 6, Issue 1, 2020 · pp. 45–55 Read article
-
Integrated Systems and transformation of Microelectronics to Nanoelectronics
Abstract: This paper is the study of transformational shift of microelectronics to nanoelectronics. Nanoelectronics are the electronic components manufactured a nanoscale. The current industry electronics is far dependent on silicon based technologies which have reached their heights working at micro scale and defined Moore’s Law. Hence, there are existing technologies which can be approached further for micro miniaturizations. Nanomaterials are of very small size than micro and they exhibit rare self-assembling …
Published in International Journal of Microelectronics and Digital integrated circuits · Vol. 1, Issue 1, 2015 · pp. 16–22 Read article