Search

3 articles for “dynamometer”

• Published Subscription 30 Jul 2020

  Remapping of ECU Engine (KTM 390)

  By Sunil Sopnur, Vedang Mahurkar, Navin Kodam, Omkar Shinde

  Abstract: Modern engines in automobile industry are controlled digitally with the help of engine management unit (EMU) which is programmed with the help of engine dyno manually to get the desired power, efficiency. Emissions Engine map of a four cylinder engine is tuned with the help of algorithm by using engine dynamometer as well as EMU, engine speed and throttle position is obtained by algorithm of air fuel ratio to obtain …

  Published in International Journal of I.C. Engines and Gas Turbines · Vol. 6, Issue 1, 2020 · pp. 15–18 Read article →

• Published Subscription 5 Feb 2020

  Effect of Cutting Parameters in Hard Turning on Chip Formation and Machined Surface

  By Shambhu Choubisa, B. P. Nandawana, M. A. Saloda, M. S. Khidiya

  Abstract: Cost effectiveness, increasing demand, high production rates and reliability of the product have increased the potential of industrial application of hard turning technology during the past few years. Grinding operation for hard steel component reduces the machining sequence, the machining time and the specific cutting energy. Hard turning also shows effects like generation of high temperature, the formation of saw toothed chips. In this thesis, experimental investigation is conducted in …

  Published in International Journal of Manufacturing and Materials Processing · Vol. 2, Issue 1, 2016 · pp. 28–47 Read article →

• Published Subscription 18 Jul 2019

  Experimental Investigation of Process Parameters on Machining Force, MRR and Power in Turning of AISI 316 Steel

  By Sadashiv Bellubbi, Vijeath A, Mithesh Gowda J.R., Karthik Prabhu

  Abstract: A machining process involves many process parameters which directly or indirectly influence the surface quality of the product. A precise knowledge of these optimum parameters facilitate reduce the machining costs and improve product quality. Current investigation aims to investigate the effect of process parameters; cutting speed, feed and depth of cut in turning of SS-316 which is widely used in automobile industries, each varying in three levels. The response characteristics …

  Published in International Journal of Computer Aided Manufacturing · Vol. 5, Issue 1, 2019 · pp. 18–25 Read article →