Search
123 articles for “grading”
-
Reuse of Building Material
Abstract: Large quantities of construction and demolition wastes are continuing being generated which are just being dumped in the landfills. This requires large areas of land which is becoming difficult to find. The best solution would be to recycle and reuse the demolished waste which would not only help in protecting the environment but also help in dealing with construction wastes. Therefore, it has a severe difficulty to harvest ecological toxic …
Published in International Journal of Construction Engineering and Planning · Vol. 4, Issue 1, 2018 · pp. 15–18 Read article
-
Simulation Models for Flexural and Compressive Strength of Concrete Using Waste Glass as Partial Replacement.
Abstract: The research present the usefulness of waste glass in the production of grade 20 concrete using partial replacement levels of 0%, 20%, 40% and 60%, respectively, for coarse glass and fine glass to coarse aggregate and fine sand aggregate. The results obtained indicate that, for the purpose of construction works, 20% replacement should be adopted either for coarse glass or fine glass replacement. Simulation models were established to predict flexural …
Published in International Journal of Construction Engineering and Planning · Vol. 4, Issue 2, 2018 · pp. 1–7 Read article
-
Compressive Strength, Water Absorption and Temperature Effects on Partial Replacing Cement with GGBS, Micro Silica and Fly Ash
Abstract: Widespread research work for decades also in development throughout the globe in concrete technology in finding substitute materials which can incompletely change Pozzolonic Portland Cement (PPC) and which can also meet the necessities of the strength and durability performance of industrial by products like micro silica, ground granulated blast furnace slag, fly ash, etc. now termed as complimentary cementations materials (CCM) are quite promising. The increased quest for sustainable and …
Published in International Journal of Construction Engineering and Planning · Vol. 4, Issue 2, 2018 · pp. 30–37 Read article
-
Smog Eating Structure
Abstract: Air quality has deteriaoted significantly over the past two decades, today pollution is one of the largest risk factors contributing to the disease’s burden, Air pollution affects individual health of citizens, increases mortality and morbidity rates and contributes in climate changes. So, in this paper we have used titanium-dioxide-infused concrete, which can remove smog from air when exposed to sunlight and ultraviolet lights. This technology is based on particles of …
Published in International Journal of Construction Engineering and Planning · Vol. 7, Issue 2, 2021 · pp. 15–20 Read article
-
Effect of Replacing Rice Husk Ash with Cement and Granulated Blast Furnace Slag with Fine Aggregates on High Performance Concrete
Abstract: Cement and sand are the basic materials for any concrete construction. Now a day’s due to erosion of rivers and considering environmental issues, there is a scarcity of river sand. Many researchers are finding different materials to replace sand and one of the major materials considered in this study is granulated blast furnace slag (GBFS). In recent times, instead of cement many alternative materials are being used as the binding …
Published in International Journal of Concrete Technology · Vol. 2, Issue 2, 2016 · pp. 30–35 Read article
-
INVESTIGATION OF STEEL FIBER REINFORCED CONCRETE CORBELS BY EXPERIMENTAL AND ANALYTICAL METHOD
Abstract: In the present paper, an experimental results and predicted values by truss analogy method, ACI Building Code (ACI 381-83) provisions for corbels, and method given by Fattuhi is investigated. The concrete used in the corbels is of M-60 grade. Test were carried out on 27 samples of size 150 x 150 x 200- mm were shear span was varied from 175 to 200 as shown in table (5) and concrete …
Published in International Journal of Concrete Technology · Vol. 2, Issue 2, 2016 · pp. 23–29 Read article
-
Use of Recycled Aggregates in Concrete to Achieve Characteristic Strength M50 with Addition to Steel Fibre
Abstract: Concrete is World’s second most consumed material after water, use of recycled aggregate (RA) in concrete can be useful for environmental protection. Recycled aggregates are the materials for the future. Aggregate is one of the main ingredients in producing concrete. It covers 75% of the total for any concrete mix. The strength of the concrete depends on the properties of aggregates used. The experimental analysis comprise with normal RAC and …
Published in International Journal of Concrete Technology · Vol. 2, Issue 2, 2016 · pp. 1–8 Read article
-
Effect of Colloidal Nanosilica on High Strength Rice Husk Ash Concrete
Abstract: Nowadays, supplementary cementitious materials (SCMs) are used in concrete because it reduces CO2 emission during. The husks, which are production of cement, reduces cement contents, improve workability, increase strength and enhance durability. Pozzolanic reaction takes place when siliceous or aluminous material comes in contact with calcium hydroxide in the presence of moisture to form compounds possessing cementitious properties approximately 50 percent cellulose, 30 percent lignin and 20 percent silica, are …
Published in International Journal of Concrete Technology · Vol. 3, Issue 1, 2017 · pp. 33–43 Read article
-
Experimental Study on the Properties of Self-Curing Concrete
Abstract: This paper highlights the effect of curing agent polyethylene glycol (PEG-400) in the performance of concrete. The chemical agent PEG is used with different percentage; 1%, 2% and 3% to the weight of cement. Super plasticizer named glenium was used to improve the workability of concrete. The property such as compressive strength and split tensile strength of concrete was examined with normal curing and self-curing at 7 days and 28 …
Published in International Journal of Concrete Technology · Vol. 3, Issue 1, 2017 · pp. 8–13 Read article
-
Utilization of Steel Slag as Course Aggregate
Abstract: Concrete is the third largest material consumed by human being after food and water as per WHO. Concrete plays a vital role in the design and construction of the nation’s infrastructure. Almost three quarters of the volume of concrete is composed of aggregate. These are obtained from natural rocks and river beds, thus degradation them slowly. This issue of environment degradation, and need for aggregates demands for the usage of …
Published in International Journal of Concrete Technology · Vol. 3, Issue 1, 2017 · pp. 14–18 Read article
-
Modulus of Elasticity of Steel Fiber Reinforced Concrete with Metakaolin
Abstract: In this paper the attempt has been made to study the results of an experimental investigation using steel fiber (SF) and metakaolin (MK) on the properties of structural concrete. Crimped steel fibers of aspect ratio 85 and MK were used in this investigation. The effects of these fiber and MK on workability, density, and on various strengths of M60 grade concrete are studied. Fiber content varies from 2.5% to 10% …
Published in International Journal of Concrete Technology · Vol. 3, Issue 2, 2017 · pp. 50–59 Read article
-
Empirical Model Relativity of Flexural and Compressive Strength of Concrete Produced with Foundry Waste Sand as Partial Replacement
Abstract: The evaluation presented in this research is to establish the correlation between compressive strength of concrete and flexural strength of concrete of grade 20 at mix ratio of 1:2:4 produced using foundry waste sand as a partial replacement for river sand at different replacement level of 0%, 5%, 10%, 15%, 20% and 25%. The aimed compressive strength was achieved at 15% replacement and the corresponding flexural strength of 3.14 N/mm2was …
Published in International Journal of Concrete Technology · Vol. 4, Issue 1, 2018 · pp. 5–10 Read article
-
Study on Partial Replacement of Cement by Bagasse Ash in Cement Concrete
Abstract: Today, researchers all over the world are trying to utilize agricultural wastes like corncob ash, rice husk ash, bagasse ash as a partial replacement of cement, thereby reducing cement production and greenhouse gases emissions. Sugarcane bagasse is a fibrous waste product of sugarcane refining industry and being disposed to open landfills causing serious environmental impacts. In this study, Bagasse ash was partially replaced in the ratio of 0%, 5%, 10%, …
Published in International Journal of Concrete Technology · Vol. 4, Issue 1, 2018 · pp. 29–35 Read article
-
Experimental Investigation On Partial Replacement Of Fine Aggregate By Wood Ash On Concrete
Abstract: This paper intends to investigate the possibility of producing low costs enhanced performance concrete by wood ash. By taking the enormous amount of sand in river beds, it affects the environment badly and demand for fine aggregate is increase day by day. So by partially replacing Prosopis juliflora ash with fine aggregate in construction field, It can serve both the purposes of meeting the demands of construction industry and at …
Published in International Journal of Concrete Technology · Vol. 4, Issue 2, 2018 · pp. 10–16 Read article
-
Investigation of strength of concrete by replacement of sand with copper slag and cement with sugarcane bagasse ash
Abstract: This investigational study conducted to observe the potential of Sugarcane Bagasse Ash as a cement replacing material which is similar to that of Portland Pozzolana Cement and Copper slag as a fine aggregate replacement material. Seven different concrete mixes with the Bagasse Ash replacement to the Portland Pozzolana cement and copper slag replacement are (5% + 40%, 10% + 15% , 10% + 25% , 10% + 35% , 10% …
Published in International Journal of Concrete Technology · Vol. 5, Issue 1, 2019 · pp. 25–38 Read article
-
Experimental Study on Partially Replacement of Fine Aggregate & Coarse aggregate by Waste Marble with addition of S-Fiber
Abstract: Today’s world is a concrete jungle. With the ever increasing population of the world, in general and the developing countries there is the tremendous pressure on the Civil Engineer to develop a cost effective as well as ecofriendly structure to fulfill the need of the human being. Concrete is a heterogeneous mixture of binding material (cement or lime), coarse aggregates, fine aggregates (sand) and water. Fine and coarse aggregates are …
Published in International Journal of Concrete Technology · Vol. 5, Issue 2, 2019 · pp. 1–9 Read article
-
Replacement of Natural Fine Aggregate by Copper Slag
Abstract: This paper presents the applications of replacement of natural fine aggregate using copper slag. The study is conducted by replacing the fine aggregate from 0 to 100% at the interval of 20% on M25 grade concrete and 1.8% superplasticizer by weight of cement. The compressive strength, split tensile strength and flexural test is studied and reported. It is observed that replacement of natural fine aggregate at 40% (CS40) gives higher …
Published in International Journal of Concrete Technology · Vol. 5, Issue 2, 2019 · pp. 23–28 Read article
-
Strength & Durability of Concrete with Sand Blasting Residue
Abstract: Sand blasting residue (SBR) is commonly obtained as a by-product from chain manufacturing industries. Although it is a waste material but can be used in the mixing of concrete. The work has been divided into two parts. Part 1 covers preparation of M20concreteby substituting SBR as replacement of sand in different percentage such as 40%, 50%, 60%, 70% & 80%. The w/c ratio is kept as 0.5 with adequate does …
Published in International Journal of Concrete Technology · Vol. 6, Issue 1, 2020 · pp. 32–41 Read article
-
Mechanical Properties of sand blasting residue concrete
Abstract: Sand Blasting Residue (SBR) form chain manufacturing companies as a large massive by-product. Steel-slag hydrated matrix is made of ground granulated blast furnace slag powder & steel-making slag which is the by-product of iron manufacturing. This type of construction material is called environmental conscious material in Japan. This research presented that the strength of steel-slag hydrated matrix depends on the pH of the steel-slag hydrated matrix after mixing. Firstly, cement, …
Published in International Journal of Concrete Technology · Vol. 6, Issue 2, 2020 · pp. 46–52 Read article
-
Experimental Investigation on the Properties of Concrete Replacing Waste Plastic as Aggregates for Solving Waste Management Problem
Abstract: Solid waste management is one of the growing problems of every country. As part of this ongoing program to consider the growing waste management, pollution problem, and prevention framework in India, the Ministry of Environment has suggested various approaches and ways through which we can either recycle or use the most polluting materials like plastic. The present study covers one of the ways through which to recycle one of the …
Published in International Journal of Concrete Technology · Vol. 9, Issue 1, 2023 · pp. 17–25 Read article