Search
802 articles for “Solutions”
-
Development of Effective Electrodes and Electricity Generation in Continuous Microbial Fuel Cell using Poultry Wastewater
Abstract: The Microbial Fuel Cell was designed for batch and continuous operations and the electrodes were developed using a simple and effective technique known as phase inversion. The different combinations of electrodes were used in the experiment to get the maximum power output and organic matter removal. The poultry wastewater was used as substrate and was comparatively studied with Luria Bertani (LB) solution. The best combination of electrode was found to …
Published in International Journal of Renewable Energy and its Commercialization · Vol. 4, Issue 1, 2018 · pp. 1–11 Read article
-
Nuclear waste heat and renewable energy derived hydrogen: Preliminary feasibility analysis
Abstract: Hydrogen, a possible carbon free energy resource of the future, can be obtained in a sustainable manner from abundantly available resource like water through low temperature, low pressure water electrolysis. This work examines the techno-economic feasibility aspects of a water electrolysis based hydrogen production plant of capacity 1000-10000 Nm3/hr, when coupled with a typical nuclear power plant in India and renewable energy resources in novel ways. The nuclear waste heat …
Published in International Journal of Renewable Energy and its Commercialization · Vol. 4, Issue 2, 2018 · pp. 7–31 Read article
-
Performance Investigation of Single Sloped Solar Still Using Sand Beds
Abstract: Although more than 2-3rd of the earth is covered with water were less than 1% of it (freshwater) is in humans, plants & animals reach for their survival. The demand in fresh water for drinking, agriculture & industry largely exceeds the amount that fresh sources can meet. Access to safe/fresh water is a challenge in many communities in developing countries. Among the available purification technologies solar powered distillation system has …
Published in International Journal of Renewable Energy and its Commercialization · Vol. 6, Issue 1, 2020 · pp. 30–40 Read article
-
Energy resources of Pakistan, Issues and crisis
Abstract: Planet has no fair distribution of energy sources. The energy sector needs to undergo a transition from fossil fuel to renewable energies and energy efficient technology to tackle global challenges.Continued economic and human growth depends on oil. In today’s existence, energy is so important that one can't even existence without it. All our acts are energy dependent. Electricity makes a big contribution to the socioeconomic progress and the nation’s national …
Published in International Journal of Renewable Energy and its Commercialization · Vol. 6, Issue 2, 2020 · pp. 26–42 Read article
-
Nanofluids for the Synthesis of Solar Thermal Energy
Abstract: The use of Al2O3-Water nano-fluids in a solar flat plate collector to increase solar energy collection and conversion is examined in this research (SFPC). Both experimental and theoretical analysis is done to determine how effective a solar flat plate collectors is while using water as the fluid medium. Al2O3- Water nanofluid was chosen as the fluid medium to increase the SFPC's capacity for solar energy collecting and conversion. A few …
Published in International Journal of Renewable Energy and its Commercialization · Vol. 8, Issue 2, 2022 · pp. 22–25 Read article
-
The Role of Energy Storage in Wind Energy Technology
Abstract: Wind energy is a promising source of renewable energy that has gained increasing attention in recent years. However, wind power generation faces the challenge of intermittent, which can lead to fluctuations in power supply and demand. The solution to this challenge lies in energy storage technologies, which can store excess wind energy during periods of high wind and release it when needed. Energy storage systems (ESS) have an important role …
Published in International Journal of Renewable Energy and its Commercialization · Vol. 8, Issue 2, 2022 · pp. 26–29 Read article
-
The Revolution of Renewable Energy: Addressing Climate Change with Environmentally Friendly Technologies
Abstract: The use of renewable energy is undergoing a revolution as a vital solution to the urgent problem of climate change. The urgent necessity to move towards ecologically friendly technologies has significantly increased as the negative impacts of greenhouse gas emissions become more and more obvious. new developments in renewable energy and its impact on combating climate change. It draws attention to the transformative potential of clean technologies like geothermal, hydro, …
Published in International Journal of Renewable Energy and its Commercialization · Vol. 9, Issue 1, 2023 · pp. 23–28 Read article
-
High-rate Deformation of Condensed Matter Followed by Self-Organization on the Mesoscale
Abstract: The purpose of the paper is to demonstrate the advantages of the developed self-consistent non-local approach to the description of processes in condensed matter far from local thermodynamic equilibrium and new opportunities for understanding and practical use of such phenomena as self-organization, multi-scale energy exchange and turbulence. This interdisciplinary approach, based on rigorous results obtained in non-equilibrium statistical mechanics with the use of feedback control laws, offers a universal mathematical …
Published in International journal of Thermodynamics and Chemical Kinetics · Vol. 8, Issue 2, 2022 · pp. 13–38 Read article
-
Thermodynamic and Kinetic Characterization of Aluminum Corrosion and Inhibition Adsorption of Vernonia Amygdalina Fruit Extract IN 0.5N H2SO4
Abstract: Anti-corrosive efficacy of ethanolic extract of Vernonia amygdalina fruit extract on corrosion of aluminum in 0.5N H2SO4 acidic solution was explored by mass loss measurement at rise in temperature between 303-343 K for 24 hours immersion period. The I.E. (η%) has been noticed prominently high (62.92%) at concentration 0.45% at 303 K. An inhibitor adsorption on the surface aluminum have been found to be best fitted Langmuir adsorption isotherm. It …
Published in International journal of Thermodynamics and Chemical Kinetics · Vol. 9, Issue 1, 2023 · pp. 20–27 Read article
-
Reuse of Building Material
Abstract: Large quantities of construction and demolition wastes are continuing being generated which are just being dumped in the landfills. This requires large areas of land which is becoming difficult to find. The best solution would be to recycle and reuse the demolished waste which would not only help in protecting the environment but also help in dealing with construction wastes. Therefore, it has a severe difficulty to harvest ecological toxic …
Published in International Journal of Construction Engineering and Planning · Vol. 4, Issue 1, 2018 · pp. 15–18 Read article
-
Selection of effective formwork system using multi criteria decision making analysis
Abstract: Formwork is the largest single cost item in constructing cast-in place reinforced concrete structure. This project focuses on analyzing the formwork selection problem based on decisive criteria. The factors affecting the choice of the exact formwork system have been often discussed in literatures but their importances have not been distinctly formulated. Therefore, a survey was conducted to recognize the decisive criteria in the formwork selection problems and ranking of the …
Published in International Journal of Construction Engineering and Planning · Vol. 5, Issue 2, 2019 · pp. 1–9 Read article
-
EXPERIMENTAL INVESTIGATION ON GEOPOLYMER CONCRETE
Abstract: The project report entitled “Experimental investigation on alkali activated concrete” describes the detailed experimental work carried out on Alkali Activated Alumina-silicate concrete [Provis and Deventer, 2009]. The fly ash- Ground Granulated Blast Furnace Slag (GGBFS) based Alkali Activated Alumina-silicate concrete cured at ambient temperature was prepared by using different molarities of Alkali Activated solution namely 8M, 12M and 16M. The properties of concrete such as workability, compressive strength, Pull-out test/bond …
Published in International Journal of Concrete Technology · Vol. 2, Issue 2, 2016 · pp. 17–22 Read article
-
An Experimental Study on Concrete by Replacement of Coarse Aggregate with Demolished Building Waste in Crushed Concrete
Abstract: A large amount of construction and demolition wastes are produced annually in India. These waste materials require a large place to dispose and then the disposal of wastes has become a severe problem. The continuous use of natural resources for making conventional concrete leads to the reduction in their availability and results in the increase of the cost of the coarse aggregate and fine aggregate. The possible use of recycling …
Published in International Journal of Concrete Technology · Vol. 4, Issue 1, 2018 · pp. 25–28 Read article
-
A parametric study for the behaviour of steel plate-anchor assembly embedded in concrete under cyclic loading
Abstract: Steel plate-anchor assembly embedded in concrete is a common type of connection system used for connecting structural steel members to concrete members. These assemblies are subjected to different loading cases depending on their use. Since the behaviour of such assemblies is quite complex and depends on a number of factors associated with different components, it was decided to adopt finite-element technique to obtain a reasonably accurate analytical solution for the …
Published in International Journal of Concrete Technology · Vol. 4, Issue 2, 2018 · pp. 21–36 Read article
-
Effect of Temperature on mechanical properties of Geopolymer concrete: A Review
Abstract: Concrete is the most widely used material after water in building and construction field. It is the oldest man-made material and is easily available for use at cheaper costs. This material is causing harm to environment on mass extent. OPC i.e. Ordinary Portland Cement is second contributor after automobile industry in Carbon Dioxide emission. This review presents the study of replacement of regular concrete cement with cementitious material like fly …
Published in International Journal of Concrete Technology · Vol. 7, Issue 1, 2021 · pp. 24–28 Read article
-
Manufacturing of interlocking brick with cement- lime mortar and hyposludge
Abstract: Lime is still a valuable building material that is frequently used in construction as lime mortar. Hydrated lime can be added to concrete mixes used to make blocks and other concrete products. Sugarcane mud, also characterized as filter cake, is a byproduct of the sugar purification process. The introduction of these components into the environment pollutes it. There have been several attempts to address these difficulties. A experiment of manufacturing …
Published in International Journal of Concrete Technology · Vol. 8, Issue 2, 2022 · pp. 1–7 Read article
-
Study on Properties of Concrete Cured With Poly Ethylene Glycol-600
Abstract: After water, concrete is the most using material globally. Without concrete, the world is unimaginable. The foundation of civilization is concrete. Coarse aggregate, cement ,fine aggregate and water are the main ingredients in concrete, which requires curing to attain its strength. Concrete must therefore cure for 28 days in order to complete the necessary hydration, desired strength. For the traditional curing processes, a lot of water is needed. This becomes …
Published in International Journal of Concrete Technology · Vol. 8, Issue 2, 2022 · pp. 14–21 Read article
-
A Review on Waste Bakelite as Replacement Partially Over Coarse Aggregate in Concrete Mix
Abstract: Various components in India are made up of Bakelite. Saffron Global Dumping of waste Bakelite through landfill is not allowed due to it effect on soil mass and open burning is not allow because of the emission of harmful gases which cause air pollution. A large space of storehouse requires to store large amount of area for keeping waste Bakelite which becomes management problem of waste. Despite managing waste Bakelite …
Published in International Journal of Concrete Technology · Vol. 9, Issue 2, 2023 · pp. 8–13 Read article
-
A Case Study of the Krishna Bhir Slope Failure Disaster: Past and Present Scenario at a Glance
Abstract: The massive landslide disaster of Krishna bhir has been infamous for its dreadful consequences. This huge landslide in the region led to serious socio-economic and environmental disorders in the vicinity of the region, whose negative impacts were reflected soon in the capital city. In addition to the feeble geology, the blasting and drilling activities, rampant deforestation, heavy monsoon rain and the poor drainage are the engenders for weakening the natural …
Published in International Journal of Geological and Geotechnical Engineering · Vol. 2, Issue 1, 2016 · pp. 21–30 Read article
-
Durability Studies on Red mud and GGBS based Geopolymer Concrete
Abstract: The aim of the study is to evaluate the performance of geopolymer concrete and conventional concrete. In the present work, two Industrial by-products such as Red Mud and ground granulated blast furnace slag (GGBS) of 25:75 proportion is used for geopolymerisation. Red mud is a by-product from Alumina industry. GGBS is a by-product from iron industry. To develop a bond between binder and aggregates to form a geopolymer concrete feldspar …
Published in International Journal of Geological and Geotechnical Engineering · Vol. 5, Issue 1, 2019 · pp. 9–17 Read article