International Journal of Structural Engineering and Analysis
Volume 6, Issue 1 (2020)
Published
Table of contents
-
Comparison between with and without horizontal bracing on sloping and plain ground: seismic zone iii
Abstract: In this work, the structure selected for study is G+12 storied regular RC residential building. The seismic analysis of 5 bays (6m x 6m room size) buildings on varying slope angles were studied and compared with the same on the flat ground. The seismic forces of zone III were considered as per IS: 1893:2002 in STAAD.Pro software for the structural analysis. In this paper columns, plinth beams, slab beams and …
Published in International Journal of Structural Engineering and Analysis · Vol. 6, Issue 1, 2020 · pp. 1–14 Read article
-
Effect of Shear Wall on Seismic Performance of High Rise Building Adopting Linear Dynamic Analysis
Abstract: Earlier, the buildings were designed for only dead loads not for the seismic loads. But, as the populations go on increasing and there is limited space available for living. So now a day we raise the height of the structures, as height is increases different parameters affects the structure like seismic loads and wind loads. Seismic force is a lateral horizontal force acting on throughout the height of the building. …
Published in International Journal of Structural Engineering and Analysis · Vol. 6, Issue 1, 2020 · pp. 15–28 Read article
-
Optimal Design of Cantilever Retaining Wall Using Relief Shelve: A Review
Abstract: The sectional dimensions of retaining wallessentially depends on the active lateral earth pressure acting on it. Many researchers have struggledon researches to minimize the effective lateral pressure and to adopt the optimized and economical design for retaining walls. Provision of relief shelves to retaining walls reduces the lateral earth pressure, this type of retaining wall is considered as a special type of retaining wall. For high cantilever wall, there will …
Published in International Journal of Structural Engineering and Analysis · Vol. 6, Issue 1, 2020 · pp. 29–39 Read article
-
Seismic Performance Of RC Elevated Liquid Storage Tank Supported On Partial Shaft Type And Full Shaft Type Staging.
Abstract: Elevated water tanks are mostly used in public water distribution system. These structures are most vulnerable under earthquake excitation due to large lumped mass concentrated at the top of slender supporting structure. In this dissertation, a comparative study is made on seismic performance of elevated intze shape water tank supported partial shaft type staging and full shaft type staging of 2,50,000 litre capacity. The analysis s carried out in accordance …
Published in International Journal of Structural Engineering and Analysis · Vol. 6, Issue 1, 2020 · pp. 40–51 Read article
-
Static Analysis of Precast Concrete Piles using Resonance Moment–Displacement Method
Abstract: This paper presents the results of static analysis of circular precast single piles from critical buckling load by resonance moment-displacement approach. The circular precast single piles of different support conditions; pinned-pinned, fixed-fixed, and fixed-pinned were investigated. The critical buckling load was evaluated as the resonance moment-total deflection ratio. A computer program coded in basic language was invoked to carry out a composite analysis of single piles from critical buckling load …
Published in International Journal of Structural Engineering and Analysis · Vol. 6, Issue 1, 2020 · pp. 52–61 Read article
-
Thermo-elastic flexural analysis of cross-ply laminated beams
Abstract: The present paper is concerned with the thermal analysis of symmetric and antisymmetric cross ply laminated beams subjected to temperature distribution across the thickness of laminated beam. A higher order shear deformation theory is used. The displacement field in terms of thickness coordinate is expanded up to cubic term to have a quadratic variation of the transverse shear strains and transverse shear stresses. This avoids the need of shear correction …
Published in International Journal of Structural Engineering and Analysis · Vol. 6, Issue 1, 2020 · pp. 62–73 Read article