International Journal of Structural Engineering and Analysis
Volume 4, Issue 2 (2018)
Published
Table of contents
-
Experimental Investigation On Replacement Of Fine Aggregate With Manufactured Sand And Partial Replacement Of Cement With Ggbs
Abstract: Concrete is the most widely used construction material in civil engineering industry because of its high structural strength and stability. The concrete industry is looking for supplementary cementitious material or industrial by product with the objective of reducing the carbon dioxide emission which is harmful to environment. Ground granulated blast furnace slag (GGBS) is the solid wastes generated by industry are used as a replacement material for cement. Manufactured sand …
Published in International Journal of Structural Engineering and Analysis · Vol. 4, Issue 2, 2018 · pp. 1–6 Read article
-
Comparative Analysis of Strengthening of RC Beam Column Joint Using Ansys
Abstract: The biggest impact of earthquake on a building structure is at the beam column joint. Many researchers have tried to find solution to minimize the beam-column joint cracks and increase the strength of joint. This article leads to the seismic analysis using ANSYS software. This article is the validation of the experimental method did by the researcher. Proposed analysis is on the same loads as in the experimental methods and …
Published in International Journal of Structural Engineering and Analysis · Vol. 4, Issue 2, 2018 · pp. 16–24 Read article
-
Wind Analysis of G+20 Storey RC Building with Different Plan Shapes
Abstract: Tall buildings are affected by lateral forces due wind & earthquake. For most of the buildings wind load is critical than earthquake load &need to be controlled by using suitable methods. Most effective & feasible solution is to modify the geometry of building. So, this paper is an attempt to study behavior of different plan shaped multistoried buildings to the wind load. Five models with various plan shapes like rectangular, …
Published in International Journal of Structural Engineering and Analysis · Vol. 4, Issue 2, 2018 · pp. 25–31 Read article
-
BASE ISOLATION: EARTHQUAKE RESISTANT CONSTRUCTION TECHNIQUE
Abstract: One of the most effective way of protecting structures against the severe earthquake is the base isolation system. In last few decades base isolation system have gain larger attention as a means in controlling structure failure against seismic hazards. In the base isolation system superstructure is separated from substructure due to which natural frequency of structure gets away from the dominant frequency range of seismic excitation. The effectiveness of an …
Published in International Journal of Structural Engineering and Analysis · Vol. 4, Issue 2, 2018 · pp. 32–37 Read article
-
Potential of Natural Fibres for Strengthening Existing Structures – A Review
Abstract: To rehabilitate the deficiencies in the existing structures, synthetic/artificial fiber reinforced polymer composites have been considered as an effective external strengthening material for construction industries since a long period, due to their outstanding performances like high strength-to-weight ratio, lightness, and resistance to corrosion. But few of their drawbacks in terms of high cost, environmental issues etc., they have been triggered the introduction and development of natural fibers. Natural fibres are …
Published in International Journal of Structural Engineering and Analysis · Vol. 4, Issue 2, 2018 · pp. 38–46 Read article
-
Literature Review on Seismic Analysis of Building Resting on Sloping Ground
Abstract: Over the past 20 years,1.35 million people have been killed by natural hazards, more than half died in earthquakes and the remaining due to weather and climate-related hazards. The poorest nations paid the highest price in terms of the numbers killed per disaster and per 1,300,000 populations. So new advance, ideal and economical techniques should be used for designing and constructing the structures. The study helps us to understand the …
Published in International Journal of Structural Engineering and Analysis · Vol. 4, Issue 2, 2018 · pp. 7–15 Read article