International Journal of Manufacturing and Materials Processing
Volume 5, Issue 1 (2019)
Published
Table of contents
-
Effect of Pulsed Current Micro Plasma Arc welding parameters on Mechanical properties AISI 304 and AISI 430 dissimilar weld joint
Abstract: In the present work, two dissimilar AISI 304 and AISI 430 sheets of 0.4mm thick welded using Micro Plasma Arc Welding. Welding input parameters like peak current, base current, pulse rate and pulse width are considered and output responses like fusion zone grain size, hardness and ultimate tensile strength of the welded joint are considered. 31 experiments are performed as per Central Composite Design (CCD) design matrix of Response Surface …
Published in International Journal of Manufacturing and Materials Processing · Vol. 5, Issue 1, 2019 · pp. 1–26 Read article
-
Electrochemical Etching on Copper Surfaces to Achieve Superhydrophobicity
Abstract: In the present study, an attempt has been made to create superhydrophobicity on copper substrate by etching the surface at different parameters (current density and time). Etching time was varied from 30 to 240 minutes. Untreated copper surface exhibited contact angle of 91.4°. The best etched surface exhibited a maximum contact angle of 142.1° for a current density of 0.01A/cm2 and etching time of 60 minutes. The structure–property relationship of …
Published in International Journal of Manufacturing and Materials Processing · Vol. 5, Issue 1, 2019 · pp. 27–31 Read article
-
A Study on Evaluation of Mechanical Properties of Reinforced Composite Developed Using Corn Husk and Glass Fibre
Abstract: With the increasing demand for the disposal of polymer wastes and environmental waste from agriculture/ farming, this research aims to develop composite materials by using glass fibre and corn husk fibres by hand lay-up technique. The fibre from the maize husk was extracted and then overlapped on glass fibre cloth films in regular or irregular orientations. The reinforcement is done with the epoxy resin. The reinforcement and harden matrix are …
Published in International Journal of Manufacturing and Materials Processing · Vol. 5, Issue 1, 2019 · pp. 32–36 Read article
-
Multi-objective Optimization of Weld Bead Geometry of Micro-plasma Arc Welded Titanium (Ti–6Al–4V) Alloy Sheets Using TOPSIS
Abstract: Titanium alloys are used in the manufacturing of aero engine components for their attractive, combined properties such as lightness, good strength-to-density ratio, corrosion resistance. In the present paper, titanium (Ti–6Al–4V) alloy sheets are butt welded using micro-plasma arc welding. Peak current, base current, pulse rate, and pulse width are considered as weld input parameters and weld bead geometry parameters, namely front width, back width, front height, back height, are considered …
Published in International Journal of Manufacturing and Materials Processing · Vol. 5, Issue 1, 2019 · pp. 37–48 Read article
-
FEA Analysis on Motor Support Assembly of Window Air Conditioner
Abstract: The objective of this paper is to analyze and optimize the motor support assembly of the window air conditioner. The redesigned motor support assembly is the combination of multiple parts of the existing product. In the motor support assembly, motor support base part is optimized to reduce the weight of the component with maximum stiffness for the applied loads and constraints. The CAD model of motor support assembly is performed …
Published in International Journal of Manufacturing and Materials Processing · Vol. 5, Issue 1, 2019 · pp. 49–56 Read article