International Journal of Metallurgy and Alloys
Volume 6, Issue 2 (2020)
Published
Table of contents
-
Recent Trends and Challenges of Lithium Sulphur Batteries
Abstract: Lithium-ion (Li-ion) batteries that are currently available in market have certain limitations due to their low energy density and do not meet the growing demands of the energy storage market. Thus, the building next-generation rechargeable Li and Li-ion batteries with the higher energy densities, better safety characteristic, lower cost and longer cycle life is vibrant to overcome the challenges of fast depleting conventional energy resources. To achieve smaller and lighter …
Published in International Journal of Metallurgy and Alloys · Vol. 6, Issue 2, 2020 · pp. 1–6 Read article
-
MWCNT AND GRAPHENE FOR IMPROVED CORROSION RESISTANCE OF MILD STEEL
Abstract: ABSTRACTThe protective coating method is a passive corrosion protection technique. The protective coating detaches the metallic surfaces from the aggressive media, such as moisture, salts, acids etc. Nanotechnology is a relatively modern development in scientific research, the development of this concept occurred over a very short period of time. One technique that has recently been used to increase the adhesive and anti-corrosive properties of polymer coatings is the addition of …
Published in International Journal of Metallurgy and Alloys · Vol. 6, Issue 2, 2020 · pp. 12–17 Read article
-
Study of Microstructure and corrosion effects of precipitation hardened high strength AA-7xxx aluminium alloy subjected to cryo rolling
Abstract: The strength and life of an alloy is the primary parameter taken into consideration while building hulls and superstructures for marine applications. Usually AA-7xxx is widely used for these applications and hence is chosen for the present investigation. Cast AA-7xxx alloy reveals distribution of soluble intermetallic compounds in the α-aluminium matrix. In order to improve the mechanical properties and condition the microstructural features, precipitation hardening (solutionizing and ageing) treatment was …
Published in International Journal of Metallurgy and Alloys · Vol. 6, Issue 2, 2020 · pp. 18–23 Read article
-
Study of the effect of Silicon oxide nanoparticles in the copper alloy
Abstract: The main objective of this paper is to study the effect of the Silicon oxide nano particles in the copper alloy which is manufactured by using the stir casting process and samples are prepared as per the ASTM standards. These specimens are tested under the mechanical tests. Due to blending of the nanoparticles the properties of copper alloy will be enhanced. so uniform ASTM samples with varying composition of nano …
Published in International Journal of Metallurgy and Alloys · Vol. 6, Issue 2, 2020 · pp. 24–31 Read article
-
MANUFACTURING AND TESTING OF CNT BLENDED NAVAL BRASS
Abstract: The Utilization of advanced technologies increased the scope of producing new materials drastically .as a result wide spectrum of nanomaterials are being produced these materials are manufactured as per the desired properties in the final material /composite. The aim of this study is to investigate the effect of CNT (Carbon Nano Tubes) reinforcement into naval brass (Cu-CNT 60%, Zinc 39%, and Tin 1%) naval brass is widely applied in the …
Published in International Journal of Metallurgy and Alloys · Vol. 6, Issue 2, 2020 · pp. 7–11 Read article