International Journal of Composite Materials and Matrices
Volume 10, Issue 2 (2024)
Table of contents
-
Structural Behavior and Fire Resistance of Shallow Steel-Concrete Composite Decks
Abstract: This study investigates the structural behavior and fire resistance of Shallow Steel-Beam-Concrete Composite (SSCC) decks, focusing on the influence of various Steel-Concrete (SC) bonding techniques. SSCC decks combine steel beams with concrete slabs, offering structural efficiency and durability under significant loads. The effectiveness of SC bonding methods is evaluated by comparing experimental results to Full Composite Action (FCA) simulations. Fire resistance in shallow floors, particularly SlimFlor systems, is analyzed using …
Published in International Journal of Composite Materials and Matrices · Vol. 10, Issue 2, 2024 Read article
-
Single-Electron System of the Group 2 Elements:A Comparative Investigation
Abstract: This study presents a comparative investigation of the single-electron systems in group 2 elements, withthe primary objective of understanding the underlying trends in ionization energy, chemical reactivity,spectral lines, and radial probability distributions. The purpose of this research is to elucidate howthese properties evolve as one moves down the group, from beryllium (Be) to radium (Ra), and toexplore the implications for theoretical models and practical applications. One of the key problemsaddressed …
Published in International Journal of Composite Materials and Matrices · Vol. 10, Issue 2, 2024 · pp. 1–17 Read article
-
Three Dimensional (3D) Structure and Morphology ofCarbon Fibers from X-Ray Microscopy (XRM) Analysis†
Abstract: X-ray microscopy is an elegant chemical imaging technique that bridges the gap between lightmicroscopy and electron microscopy. Vital information on the chemical state (valency, surfacefunctionality), chemical composition, three-dimensional (3D) chemical structure (order, disorder,rupture), and chemical imaging can be obtained from X-ray microscopy. In the current originalresearch article, X-ray microscopy is used as a characterization tool to examine the microstructuralfeatures of commercial carbon fibers. Pitch-based (NX100) and polyacrylonitrile (PAN)-based(T700SC) CFs chosen …
Published in International Journal of Composite Materials and Matrices · Vol. 10, Issue 2, 2024 · pp. 23–32 Read article
-
One-Step Fabrication of Superomniphobic Pvdf-HFPSiO2Membrane for Long-Term CO2 Absorption inMembrane Gas Absorption System
Abstract: Membrane pore wetting is one of the major challenges for membrane gas absorption, especially when low surface tension liquid absorbents such as amine absorbents are utilized. To minimize diffusion resistance across the membrane, maintaining a non-wetted operating mode in membrane gas absorption is crucial. In this study, a superomniphobic polyvinylidene fluoride-cohexafluoropropylene membrane was fabricated by adding silica nanoparticles (SiO2) in an ethanol coagulation bath through non-solvent-induced phase separation. The surface …
Published in International Journal of Composite Materials and Matrices · Vol. 10, Issue 2, 2024 · pp. 35–44 Read article
-
Mechanical Behavior of Calotropis Gigantea FruitBunch Fiber-Epoxy Composites
Abstract: Global warming solutions in the modern era are centered on substituting environmentally friendly biodegradable materials for fossil fuels to slow down the rate at which they are being depleted. The study literature supports the use of substitute materials for plastics in the creation of composite materials, and this work envisions the use of Calotropis gigantea fruit bunch fiber as one such substitute material. Since Calotropis gigantea fruit bunch fiber is …
Published in International Journal of Composite Materials and Matrices · Vol. 10, Issue 2, 2024 · pp. 45–58 Read article